First, electroplating. Plating is every five full class. Such as supporting buckle products are essential important components.
1. From the special class of electroplating, it is divided into electric understanding and electric control. Low division machine City to promote the family of rolling electric products for the appearance of the five buckle is not high requirements of the products. It electroplated five whole products whose surface will not be very bright. There will be flower marks.
Of course, plating or Ben is also lower. Corns. Push nails, five claws, the bottom of the button three generally for the German electricity. The electric control is used in the appearance of the five buckle product requirements than the higher products. Such as the whole father face, small five full pin buckle, five full chain – general for electricity control.
2, from the ring depth can be divided into: limited electric appliances without electroplating. Electroplating is the chemical treatment of color to thin. Attached to the surface of the product. If you put “some” in the electroplating process. It will lead to non-compliance with the national environmental standards for electrical inlaying: such as in the electroplating process + no “” ingredients to be added. It is no chopsticks electroplating. Of course, five whole products without chopsticks plating also has requirements for raw materials. If the raw material itself contains “slightly” that can not do no chopsticks plating.
3, commonly used electroplating color are: green copper black steel red copper, fan LAN, dumb numerous, black numerous, light fruit Li, class fruit chopsticks, etc.
Two, spray paint (spray oil). Spray oil in addition to holes with any food collar color. There’s also the difference in brightness that light is caused by. Half a light oil. The oil. Spray into Ming oil commonly known as spray frame oil. Mainly to do acid treatment or surface protection. Oiling refers to the removal of surface protrusions after spraying oil.
Three, button must be used to match the model month. The production of coarse buckle is made of custom-made mold so the button is also used to make custom-made button die ignore the use of other manufacturers of button die; Because buttons made by many manufacturers may look the same. But the effect is different. Models from different manufacturers produce different buttons: button products. Don’t use the buttoning mould you can get from other channels.
Post time: Nov-14-2022
